1、Operating volt: DMM1 is 220V, single-phase, max power 2000W. DMM2 is 2000V, single-phase, max power 3000W。
2、 Output volt: Basis specific going DMM1 can adjust between 100V-400V. DMM2 is 2000V.
3、The equipment can automatically stop or start to charge when it get to enactment volt, and can automatically tardily discharge. There are also have a function that can give an alarm when exceed enactment volt.
4、Don’t use short wire(<=3M) to fill magnet, otherwise easily break away the rectifier.
5、The equipment adapt to Nd-Fe-B\ Ferrite Magnets\ Rubber Magnets\ Plastic Magnets. It has rapid\ efficient and much protecting systems of important parts. For example single once can saturation fill magnet FERRITE20-25kg。
6、Operation: Link with magnetic wire, the linker must be tightly, turn on the chief power supply, the power supply signal lamp will be light. Press the charge button, the charge signal lamp will be light, at one time the volt tardily raise in the direct current volt surface. It will automatically stop charging and the magnetic signal lamp be light, then it can start to fill magnet. The equipment allow to magnet or demagnetize when it doesn’t receive the enactment volt